How to Use Geocodes Instead of Address in Map Mashup
You can use the General Instructions to plot addresses on a map, however to plot latitude and longitude instead of address, use the code segment below in steps 1.3 and 1.4 of the instruction at link above:
Find this code:
Replace with new code:
Make sure this change is applied to both places where the old code appears and that you replace lat and long with the actual table field names for latitude and longitude.
Additional Customization for Geocoded Data with Google Maps:
An optimized deploy code is available for geocoded data on Google maps for faster load time.
1. Find the following code segment on the 2.2.1 section of the instructions:
2. Replace with new code: